How to Look Like a Champ at the Boat Ramp

Few things are more intimidating for new boaters than using a public boat ramp. That’s especially true if the ramp is busy and packed with more experienced mariners who are watching your every move.

However, with some simple preparation and practice, launching and retrieving your boat can be far less stressful, as well as safe and efficient.

 

Pre-Launch Preparation

If possible, take someone along with you to help with the process. If not, ask others at the ramp for some assistance. They’ll likely be more than eager to help.

Most boat ramps provide staging areas where you can prep the boat without getting in the way of other boaters ready to launch their craft. To start, remove trailer tie-down straps, except for the bow winch strap and safety chain, which should remain secured until the boat is positioned for launching. Make sure the boat’s drain plug is in place, check fuel levels, inspect safety equipment, and check the battery is charged by toggling the drive or engines to see that they move – but don’t start the motor.

Next, load coolers, fishing equipment, life jackets, and other supplies from your tow vehicle to the boat before heading down the ramp. Also attach docklines to the bow and stern and put out your fenders.

 

Backing Down the Ramp

Slowly approach the ramp while checking that your path is clear of obstacles. Backing a trailer can be counter-intuitive for those not used to the procedure. However, a simple tip is to place one hand at the bottom for the steering wheel, which helps because moving your hand left moves the trailer left, while moving it right moves the trailer right.

Back slowly down the ramp, making small steering adjustments. Use mirrors and a spotter when available, ensuring the spotter remains visible and clear of your vehicle’s and boat’s path. Stop when the trailer is sufficiently submerged to float the boat without allowing the tow vehicle’s rear wheels to enter the water. Place the vehicle in park and engage the parking brake.

 

Launching the Boat

Once the boat is in position, secure it with a dockline to the courtesy dock before disconnecting the bow winch strap and safety chain. Carefully guide the boat off the trailer, using the engine only when appropriate.

Tie the boat near the end of the dock away from the busiest part of the boat ramp before parking the tow vehicle. Alternatively, you or your spotter can take it to a designated waiting area in the water while the vehicle is parked. Never leave the tow vehicle and trailer blocking the ramp while organizing equipment or passengers.

 

Retrieving and Loading

When you are finished with your boating adventures for the day, before heading back to the ramp, secure loose equipment, prepare docklines, and watch for other boaters. Tie up to the courtesy dock as far from the ramp as possible while you retrieve the tow vehicle.

Once again, back the trailer into the water to the appropriate depth. Then, slowly guide the boat onto the trailer, aligning the bow with the centerline and trailer guides. Avoid using excessive engine power when loading.

Now, attach the winch strap and carefully winch the boat into position. Secure the safety chain before pulling the trailer out of the water.

 

Final Checks

Once loaded, move the trailer and boat to the designated staging area so that the ramp is clear for others. Install transom tie-downs, raise and secure the engine, check trailer lights, and remove the drain plug to prevent water accumulation.

Patience and courtesy always are an important part of the boat-ramp process. And, with experience, these procedures will become routine, allowing you to spend less time at the ramp and more time enjoying the water.